Roland VS-2000 Appendices page 42

Algorithm List
Guitar Amp Modeling (Guitar Amplifier Modeling)
Models a guitar amplifier.
fig.08-34
Input L
Input R
Parameter (full name)
NS (Noise Suppressor):
Sw (Switch)
Thresh (Threshold)
Release (Release)
AMP (Pre-Amplifier):
Sw (Switch)
Amp Type (Pre-amplifier type)
Gain (Gain)
Bright (Bright)
Volume (Volume)
Bass (Bass)
Middle (Middle)
Treble (Treble)
Presence (Presence)
Master (Master)
Sp (Speaker Simulator):
Sw (Switch)
Sp Type (Speaker Type)
Mic Setting (Microphone Setting)
MicLvl (Microphone Level)
DirLvl (Direct Level)
*1: Can be set only when JC-120, Clean Twin or BG Lead is selected for Pre-amplifier Type.
*2: Cannot be set when Match Drive is selected for the Pre-amplifier Type.
*3: The setting range is -100 to 0 when Match Drive is selected for the Pre-amplifier Type.
42
Noise Suppressor
Setting Function
Mutes noise in the silent mode.
On, Off Turns the noise suppressor on or off.
0–100 Sets the level to start muting noise.
0–100 Sets the time over which the volume will drop to 0 after the noise starts being muted.
Models the pre-amplifier section of a guitar amplifier.
On, Off Turns the compressor on or off.
See the column on
the next page. Sets the type of the guitar amplifier.
Low, Middle, High Sets the degree of sound distortion on the pre-amplifier.
On, Off You can set this on to generate clear-cut bright sounds.
0–100 Sets the volume and degree of distortion of the amplifier.
0–100 Sets the tone of the low range.
0–100 Sets the tone of the middle range.
0–100 Sets the tone of the High range.
0–100 (-100–0) Sets the tone of the ultra-High range.
0–100 Sets the volume of the entire pre-amplifier
Models a speaker.
On, Off Turns the speaker simulator on or off.
See the column on
the previous page. Sets the speaker type.
1, 2, 3 Sets the location of the microphone that is recording the sound of the speaker.This can be adjusted
in three steps, with the microphone becoming more distant in the order of 1, 2, and 3.
0–100 Sets the microphone volume.
0–100 Sets the volume of the direct sound.
G-Amp Speaker Modeling
Output L
Output R
*1
*2
*3