Connecting An Adat To The Vm-3100Pro - Roland VM-7100 Connection Manual

(13) Connecting an ADAT to the VM-3100Pro

• Transferring audio via digital connection between the ADAT and the VM-3100Pro.
• The ADAT can be controlled with the VM-3100Pro's transport buttons such as play and stop.
Connection
fig.13
S
C
T
Equipment required
VM-3100Pro, DIF-AT, ADAT
Turning on the system
Connect the equipment and then turn the power on in the following order.
ADAT VM-3100Pro
Settings
VM-3100Pro
SYSTEM PREF page
• MasterClk:
• LocatorType:
• RecorderType:
After you turn on the VM-3100Pro, even if MasterClk is set to INTERNAL, move the value dial to select another
setting, then set it again to INTERNAL to make the setting active.
SYSTEM MIDI page
• TimingMon:
• Transport:
DIF-AT PREF
• ClockSel:
• AudioSel:
• TC Master:
To transfer the time code from the DIF-AT to the VM-3100Pro, and output it as MTC (MIDI time code) from the MIDI
OUT on the VM-3100Pro
• ThruToMTC:
The track status on the ADAT can be changed with the VM-3100Pro.
REC TRACK SEL page
EZR OUT page
Transmitting the output from channels 1-8 directly to R-BUS 1-8
• Tr1/2=: CH01/02
• Tr3/4=: CH03/04
• Tr5/6=: CH05/06
• Tr7/8=: CH07/08
ADAT
• INPUT: DIGITAL
The VM-3100Pro works with only a 44.1kHz sampling rate, and there are some limitations upon connecting the ADAT
digitally via the DIF-AT. For the details, please refer to the VM-3100Pro owner's manual p. 64.
VM-3100Pro
Sampling Clock
Control Signal
Time Code
[SYSTEM]
INTERNAL
TIMECODE
TAPE
[SYSTEM] [F1-F4 ON/OFF]
TIMECODE
RECORDER
[LEVEL METER] [F1-F4 ON/OFF]
RMDB-2
adat
adat
ON
[LEVEL METER]
[EZ ROUTING] [F1-F4 ON/OFF]
R-BUS
S
C
T
[F2](MIDI)
[F3](MTR)
[F1-F4 ON/OFF] [F3](MTR)
[F2](OUT) (CURSOR
DIF-AT
SYNC
S
C
POWER
IN OUT
OPTICAL
OUT
IN
T
SYNC IN
adat
[F1-F4 ON/OFF] [F4](PREF)
[SELECT] 1-8
)
19