Connecting And Synchronizing Multiple (Two) Tascam Da Series Recorders With The Vm-7200/7100 With Word Clock - Roland VM-7100 Connection Manual

(6) Connecting and synchronizing multiple (two) TASCAM DA
series recorders with the VM-7200/7100 with word clock
• Transferring audio via digital connection between the TASCAM DA series and the VM-7200/7100.
• TASCAM DA series can be controlled with TASCAM RC-848.
* TASCAM DA series: DA-98/88
Connection
fig.08
MIDI INTERFACE
MIDI IN
T
VM-C7200/C7100
Sampling Clock
S
C Control Signal
T Time Code
Equipment required
VM-7200/7100 [equipped with the VM-24E sold separately], VM-C7200/C7100, DIF-AT, TASCAM DA-98/88*, TDIF cables
(PW-88D), SYNC cables (PW-88S), RC-848, RC-848 Remote cable, MIDI cable
* SY-88 Synchronizer Board is required to use MIDI with the DA-88
* DAT recorder, MIDI sequencer (if necessary)
Turning on the system
Connect the equipment and then turn the power on in the following order.
DA-98/88 (1st and 2nd units)
Settings
VM-C7200/C7100
R-BUS CONFIG page [SHIFT]+[SYSTEM(PROJECT)]
• DIF-AT CONTROL TARGET:
SYS DIGITAL page
• WORD CLOCK SOURCE:
SYS SYNC/MMC page
• SYNC MASTER:
• FRAME TYPE:
SYS MIDI page
• MIDI THRU CONSOLE:
Press [PLAY] and wait for the time code coming in.
10
COMPUTER
(MIDI Sequencer)
MIDI IN
VM-7200/7100
MIDI THRU
VM-LINK
VM-7200/7100 Processors
DA-88 (1st and 2nd units)
[SHIFT]+[SYSTEM(PROJECT)]
MULTI 9-16
[SHIFT]+[SYSTEM(PROJECT)]
EXT, MTC
in accordance with the DA-98/88
Default setting on the DA-98 is 29.97DF (29D).
[SHIFT]+[SYSTEM(PROJECT)]
THRU
WORD CLOCK MASTER
S
1-8
9-16
DIGITAL B
(AES/EBU) IN/OUT
or
DIGITAL A IN/OUT
DIGITAL IN/OUT
T
DAT Recorder
VM-C7200/C7100 Console
(CURSOR) [F1](SYSTEM CONFIG)
(CURSOR) [F1](DIGITAL I/O)
(CURSOR) [F3](SYNC CLOCK)
(CURSOR) [F4](MIDI)
TASCAM
RC-848
DIF-AT
R-BUS
POWER
WORD
TDIF
SYNC IN
S
S
MIDI OUT
TASCAM
DA series
DIF-AT
R-BUS
POWER
TDIF
TASCAM DA series (CHASE)
[PAGE DOWN](R-BUS 1/2)
C
SYNC IN
SYNC OUT
T C S
SYNC IN