M.2 solid-state drive holder
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
For access, do the following:
1. Remove the side panel. See "Side panel" on page 52.
2. Remove the PCI-Express card. See "PCI-Express card" on page 86.
3. Remove the M.2 solid-state drive. See "M.2 solid-state drive" on page 90.
Removal steps
Remove the M.2 solid-state drive holder.
System board
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Avoid contact with hot components inside the computer. During operation, some components become hot
enough to burn the skin. Before you open the computer cover, turn off the computer, disconnect power, and
wait approximately 10 minutes for the components to cool.
92
ThinkStation P5 Hardware Maintenance Manual
, and print the following instructions.