Note: During installation, ensure that you connect the gray cable to the connector labeled AUX on the card,
and the black cable to the connector labeled MAIN.
Wi-Fi antenna
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the side panel. See "Side panel" on page 52.
2. Remove the top cover. See "Top cover" on page 55.
3. Remove the optional hard disk drive and bracket. See "Optional hard disk drive and bracket" on page
64.
4. Remove the Wi-Fi card. See "Wi-Fi card" on page 74.
Removal steps
Remove the Wi-Fi antenna.
Ambient temp sensor
Prerequisite
Before you start, read
Generic Safety and Compliance Notices
For access, do the following:
, and print the following instructions.
.
Chapter 6
Hardware removal and installation
75