Maintenance & Care - Bissell PROHEAT 2X 8930 Series User Manual

Maintenance & Care
machine storage
Once your cleaning is complete, make sure the
2-in-1 water tank is emptied, rinsed out, and
dried before the next use. The formula tank can
remain filled and ready to go.
notE: Store cleaner in a protected, dry area.
Since this product uses water, it must not be
stored where there is a danger of freezing.
freezing will damage internal components and
void the warranty.
machine care
For best results, a few simple steps can assure
your machine is well maintained
after your cleaning is complete.
1. Flush your machine of any remaining residual
solution.
a. Fill the 2-in-1 clean water tank with clean
hot tap water.
b. Plug your machine into a proper outlet
and set the Custom Clean dial to the rinse
setting. Turn the power on by pressing the
power button.
c. Recline the handle and press the spray
trigger for 15 seconds while making forward
and backward passes on carpet. Release the
trigger to suction. Repeat for another 15 sec-
onds. Continue without pressing the trigger
until there is no more water being suctioned.
2. Turn power and heater switches OFF (O).
Unplug the machine and wrap the power cord.
empty the 2-in-1 water tank.
3. Rinse out 2-in-1 water tank, with running hot
tap water, taking care to clean underneath the
heavy duty bladder, and all around it.
4. The top half of the tank can be rinsed clean
through the nozzle area. Also, pop out the red
filter underneath the top half of the tank and
rinse out. Replace before putting the top and
bottom halves of the tank together.
WaRnInG
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
3 & 4
www.bissell.com
Tip
» Let all parts
dry completely
before storing
Filter
800.237.7691
13