Bissell PROHEAT 2X 8930 Series User Manual page 9

Operations
3. if the area has already dried, separate and
remove from the carpet whatever semi-solids
and residue that can be accessed before deep
cleaning.
4. be sure to test any spot removal formulas in
an inconspicuous area first. This is important as
some dyes and materials could be damaged or
discolored by cleaning solvents. if such a change
should occur, try a different solution or call a
professional.
5. if cleaning on berber carpeting, gently run
your machine over a hidden area.
if no fuzzing occurs, continue cleaning
in soiled area.
6. Using the bissell stain PreTreat, spray
evenly over soiled area. Do not overwet. Wait
3-5 minutes. Gently work the solution by blotting
area with a clean, damp, color safe cloth.
7. Clean using either the FlOOR CleANiNG, or
TOOls setting on the ReadyTools dial.
cleaning with the Stain trapper tool
1. Attach the stain Trapper tool to the end
of the hose.
2. Gently scrape up any semi-solids with a spoon
or spatula. Do not use a knife or other utensil
with sharp edges because it could
damage the carpet or upholstery.
3. Plug in and turn on the power switch.
4. Clean by pressing the trigger to spray solu-
tion onto the area to be cleaned. slowly move
the tool back and forth over the soiled surface.
Release the trigger to suction soiled water.
Continue to clean in the area, working in small
sections, until no more dirt can be removed.
Rinse (optional) and suction as needed.
caUtIon: Do not overwet.
5.
notE: Do not fill the Stain trapper tank
above the fUll line.
5. To empty the stain Trapper tool, rotate
the small tank on the bottom of the tool
to unlock it.
notE: be careful to keep the top of the tool
facing upward or soiled water will spill out of
the tank.
7.
6. Dump dirty water into a sink or toilet and
rinse the tank out with clean water. Replace
the tank by lining up the "unlock" symbol with
the small arrow on the tank and turning it to
the "lock" symbol.
7. Clean the front of the tool by removing the
plate over the suction path. Pull down on the
bottom of the plate to remove. Run the tool
and the plate under clean water to rinse taking
care to remove all debris. Replace the front
plate by sliding it back into place.
www.bissell.com 800.237.7691
11