Rimage DL5200 User Manual page 18

Rimage DL5200/DLN5200 User Guide
c. Manually rotate the lead screw
counterclockwise to move the lift arm
down to the print pad.
3.
Check the disc alignment.
To see if the disc is centered, observe the
gap between the edge of the disc and the
raised edges as shown by the arrows.
If the disc requires side to side alignment,
continue to step 4.
If the disc requires front to back alignment,
continue to step 5.
4. If necessary, perform a side to side
alignment.
a. Loosen the two side to side alignment
screws.
b. Slide the printer until the side gaps are
equal.
Important! Slide the entire printer,
not the printer tray.
c. Tighten the two side to side alignment
screws.
5. If necessary, perform a front to back
alignment.
a.
Turn the front to back alignment screw
until there is a 1/16" (1.5mm) gap
between the front edge of the disc and
the raised edge of the disc retainer.
Tip: You can use the Torx T25
driver, or 5/32" Allen wrench, to turn
the front to back alignment screw.
16
Front to Back Alignment Screw
Side to Side Alignment Screws
Disc Retainer
Gap Distance
Print Pad
Lead Screw
110768_F