Maintain The Dl5200/Dln5200; Preventive Maintenance Schedule; Align The Everest Printer - Rimage DL5200 User Manual

Maintain the DL5200/DLN5200

The procedures in this section will help keep your DL5200/DLN5200 in optimum operating condition.

Preventive Maintenance Schedule

Maintenance Procedure
Cleaning the Rimage
DL5200/DLN5200
Aligning the Everest printer

Align the Everest Printer

When the Everest printer is installed or replace, you may need to align it to the lift arm.
Tools Needed: Torx T25 driver
Before you begin:
Power on the Rimage DL5200/DLN5200 autoloader. Wait for the unit to initialize.
Note: The Everest printer takes 2 to 3 minutes to complete the initialization.
1. Select Diagnostic test 4 - jog lift diagnostic.
a. Press and hold the operator button to place the unit in diagnostics mode. The operator panel
indicates when to release the button.
b. When the operator panel displays 01 CYCLE OUTPUTS DIAGNOSTIC, press the operator button
four times and hold on the fourth press. This selects the JOG LIFT DIAGNOSTIC TEST. The lift
arm moves down toward the print drawer as the printer tray opens.
c. When the operator panel prompts you to place a disc, place a disc on the print pad.
2. Check the printer alignment.
a. Press the operator button to move the
lift arm closer to the print pad.
b. Press the operator button again and the
lift arm moves down and picks up the
disc.
110768_F
Maintain the DL5200/DLN5200
Schedule
Once a week. Using a damp, lint free cloth, remove dust from the
autoloader and surrounding work area.
On installation and as needed. Refer to the instructions below.
Lift Arm
Disc
Print Pad
Printer Tray
15