Rimage Amigo II Hardware Manual page 2

Align the lift arm to the carousel
4. Place a disc on the gripper board assembly by
pushing the disc into the gripper while pressing the
disc release button. Release the disc release
button, the gripper holds the disc.
5. Manually, slowly lower the lift arm and disc to the bin.
Important! Do not move the carousel.
6. Observe the position of the disc at the four points
shown, but do not adjust the lift arm at this point.
7. Repeat steps 2 – 6 for each bin.
2 © 2007, Rimage Corporation
Gripper
Disc
Release
Button
112161_B