Macintosh Configuration; Configuring Macintosh; Changing To Ethertalk - Ricoh AP400 Network Manual

6. Macintosh Configuration

Configuring Macintosh

This section describes how to configure a Macintosh computer to use EtherTalk.
The actual procedures to configure a Macintosh may vary depending on the ver-
sion of the Mac OS. The following procedure describes how to configure Mac OS
9.1. If you are not using Mac OS 9.1, see the manual that comes with your version
of Mac OS for more information.
Basic Procedure
Change to EtherTalk
Configure the printer
Change the printer name
Change the zone
Limitation
❒ The required version of Mac OS is 8.6 or later. (Mac OS X Classic environment
is supported.)

Changing to EtherTalk

The following procedure is for configuring a Macintosh computer to use
EtherTalk.
Reference
For more information about installing the software required for EtherTalk,
see the Macintosh manuals.
Mac OS
A A A A
Open [Control Panel], and then double-click the [AppleTalk] icon.
B B B B
On the [Connect via:] pop-up menu, select "Ethernet".
C C C C
If you change zones, select a name on the [Current zone:] pop-up menu.
D D D D
Close the [AppleTalk] dialog box.
E E E E
Restart the computer.
79