5.3
Function setting before use
Turn the endoscopic CO
Press the power switch to turn the endoscopic CO
Selecting the gas supply source
Connected to a gas cylinder
1
Set the gas source selection switch on the rear panel to the "Cylinder" mode. (See
Figure 5.1)
2
The gas pressure display shows the gas supply
pressure of the CO
pressure drops below the minimum required
level, an alarm tone is generated, the red LED
is illuminated and the instrument stops
automatically.
Connected to the medical gas supply of the hospital
1
Set the gas source selection switch on the rear panel to the "Pipeline" mode.
2
A green LED in the gas pressure display
illuminates. The gas supply operation
described on the previous page is not available
in this mode.
UCR INSTRUCTION MANUAL
regulation unit ON
2
regulation unit ON. The power indicator lights up.
2
cylinder. If the supply
2
5.3 Function setting before use
Cylinder mode
Figure 5.1
Pipeline mode
Figure 5.2
Ch.5
47