Using The Bodypack Transmitter; Switching The Bodypack Transmitter On/Off - Sennheiser SK 100 G3 Instructions Manual

Using the bodypack transmitter

To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of the receiver).
2. Switch the bodypack transmitter on (see below).
The transmission link is established and the receiver's RF level display
"RF" reacts.

Switching the bodypack transmitter on/off

Push the two battery compartment catches
compartment cover µ.
¸
To switch the bodypack transmitter
Briefly press the ON/OFF
ON/OFF
The bodypack transmitter transmits an RF signal. The stan-
dard display "Frequency/Name" appears on the display
panel. The red ON
icon is displayed.
You can switch the bodypack transmitter on and deactivate the
RF signal on switch-on. For more information, see below.
To switch the bodypack transmitter off:
Press the ON/OFF button
ON/OFF
display panel.
¿
The red ON LED goes off and the display panel turns off.
When in the operating menu, pressing the
cancel your entry (ESC function) and return you to the current
standard display.
To switch the bodypack transmitter
switch-on (offline operation):
Press the ON/OFF button
ON/OFF
the display panel.
Press the SET button.
SET
The transmission frequency is displayed but the bodypack
transmitter does not transmit an RF signal. The transmission
icon is not displayed.
MHz
543.200
ew100 G3
P MUTE
AF
Use this function to save battery power or to prepare a bodypack
transmitter for use during live operation without causing inter-
ference to existing transmission links.
Using the bodypack transmitter
¸
and open the battery
¸
µ
on (online operation):
button .
¿
LED lights up and the transmission
until "OFF" appears on the
ON/OFF button
on and to deactivate the RF signal on
until "RF Mute On?" appears on
¿
will
11