Raymarine Mk II Installation Manual page 9

MK II Wheel Drive
4. Align the cover with the wheel drive:
• the two pre-drilled holes (marked with an arrow) must line up with their matching pair
of threaded inserts on the drive ring (also marked with an arrow)
• make sure that the other spoke clamp holes align with their threaded inserts
The cover will only fit back onto the wheel drive when you have aligned the two parts correctly.
Note:
Pre-drilled holes
(marked with arrow)
Front cover
5. Fit the cover back onto the wheel drive:
• press the cover in the three places shown on the diagram below to push each of the
posts back into its locating socket
This step is easier with the clutch engaged.
Note:
Pair of threaded inserts
(marked with arrow)
Drive unit
9
Drive ring