14
154 mm
(6.1 in)
8. When the pedestal bracket is correctly positioned and aligned, mark around the inside of
the slots, then remove the bracket.
9. Use a center-punch to mark the center of each slot, then use the smaller supplied drill bit
to drill a 4.0 mm (
Note:
Drill at right angles to the pedestal surface.
10. Hold the bracket in place then lightly tighten the four cross-head screws (No 10 x
As you do this, make sure the bracket is correctly aligned.
11. Replace the wheel, making sure that you locate the pin in the correct slot (slot 1 or slot 2).
12. Turn the wheel with the clutch off to check that the bracket is correctly positioned and
aligned.
5
/
in) diameter hole.
32
MK II Wheel Drive
3
/
in).
4