Table of Contents
Advertisement
MK II Wheel Drive
Drilling the spoke clamp holes
1. Remove the wheel drive front cover:
• the front cover is held onto the wheel drive by three 'push-fit' posts which sit in three
sockets on the drive ring
• to remove the cover, hold the motor in one hand and use your other hand to pull the
cover up and away from the drive unit (as shown below)
2. Identify the appropriate spoke clamp holes for your wheel. With the arrow at the top, refer
to the following diagrams:
• the holes are numbered inside the cover (e.g. if you have a 5 spoke wheel, you need to
drill the 4 locations marked with '5')
• mark the appropriate spoke clamp holes and check them by holding the cover against
your wheel
5 spokes
Top 2 spoke clamp holes
are pre-drilled
7
7 spokes
Advertisement
Table of Contents
