Correct Mounting Position - Raymarine FishFinder L265 Instruction Manual

Average transom angle–
no wedge necessary
2 to 5
For fiberglass hull – 1/8" to 1/4" (3.2 to 6 mm)
For aluminum hull – 1/4" to 3/8" (6 to 9 mm)
No!
The bow of the transducer
is above the bottom of the
transom, creating
cavitation.
Insert screws 1 and 3
1/4" from the bottom of
slots, and screw 2
1/4" from the top of the
slot to allow room for
adjustment.
If screws are inserted
this way, it won't be
possible to make the
height adjustment.
8
Vertical transom –
place wedge this way
2 to 5
No!
Rivets on the hull are
creating bubbles.
Lower the transducer
a bit.
1 2 3
Correct
alignment
Incorrect
alignment
Sloping transom–
place wedge this way
2 to 5
No!
The rear of the transducer
is too high, creating
cavitation.
Fig. 2-5
Correct Mounting
Position
Fig. 2-6
Mounting
the Transom-
Mount
Transducer
Installation