Rangemaster Kitchener 110 Electric Users Manual & Installation page 27

Installation & service instructions
Table of Contents

Advertisement

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
19. To Remove the LH Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the
rear of the unit. Remove the fi xings that secure the cover
and lift it clear.
Remove the 2 screws 'A' and allow the plate to drop
down. Remove the 2 screws B, lower the upper plate and
remove through the slot in the cooker back.
Undo the terminal connections, noting their positions.
Remove the element fi xings and withdraw element.
Replace the element and re-assemble parts in reverse
order.
Top Element
Open the LH oven door and undo the fi xings that secure
the heat shield. Remove the top element bracket fi xings
and withdraw element. Replace the element and re-
assemble parts in reverse order. Check that the oven
operates satisfactorily.
20. To Change Oven Light Bulb.
Disconnect from electricity supply.
Make sure the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It may
be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Fit an Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Screw in the new bulb, screw back the bulb cover. Turn
on the electricity supply and check that the bulb now
lights.
21. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from
grill roof, 2 screws and washers. Remove 2 screws
and washers securing the grill element front support.
Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from
the element terminals noting their position. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and remove
cover and disconnect the terminals from the rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kitchener 110 ceramic

Table of Contents