Rangemaster Kitchener 110 Electric Users Manual & Installation page 17

If there is an installation problem and I don't get my
original installer to come back to fix it who pays?
You do. Service organisations will charge for their call-
outs if they are correcting work carried out by your
original installer. It's in your interest to track down
your original installer.
Current Operated Earth Leakage Breakers
Where the cooker installation is protected by a
30 milliamp sensitivity residual current device (RCD),
the combined use of your cooker and other domestic
appliances may occasionally cause nuisance tripping.
In these instances the cooker circuit may need to be
protected by fi tting 100mA device. This work should
be carried out by a qualifi ed electrician.
Power failure
In the event of a failure in the electrical supply the
hotplate may be lit using a match.
Food is cooking too slowly, too quickly, or burning
Cooking times may diff er from your previous
oven. Check that you are using the recommended
temperatures and shelf positions. See the oven
cooking guide. The oven control settings and cooking
times are intended to be used only as a guide.
Individual tastes may require the temperature to be
altered either way, to get the results you want. Try
cooking at a higher temperature setting.
The oven is not cooking evenly
Do not use a tin or baking tray larger than 340mm x
340mm.
If you are cooking a large item, be prepared to turn it
round during cooking.
If two shelves are used, check that space has been
left for the heat to cir cu late. When a baking tray is put
into the oven, make sure it is placed centrally on the
shelf.
Check that the door seal is not damaged and that the
door catch is adjusted so that the door is held fi rmly
against the seal.
A dish of water when placed on the shelf should be
the same depth all over. (For example, if it is deeper
at the back, then the back of the cooker should be
raised up or the front lowered). If the cooker is not
level arrange for your supplier to level it for you.
Oven not coming on when turned on manually
Is the power on? Is the clock illuminated?
If not there may be something wrong with the power
supply. Is the cooker supply on at the isolator switch?
Has the time of day been set?
Is the key symbol ( ) showing in the display? See the
Clock section of the instructions for more information
on the key lock feature of the clock.
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol ( ) showing in the display? See the
Clock section of the instructions for more information
on the key lock feature of the clock.
Oven temperature getting hotter as the cooker gets
older
If turning the knob down has not worked or only
worked for a short time then you may need a new
thermostat. This should be fi tted by a service person.
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under the
guarantee) from a good electrical shop. Ask for an
Edison screw fi tting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300 °C. See
the HELP leafl et for spares by mail order.
Turn off the power supply.
Make sure the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning anticlockwise. It
may be very stiff .
Taking care to protect your fi ngers in case the bulb
should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover.
Turn on the electricity supply and check that the bulb
now lights.
17