Table of Contents
Advertisement
™
SlimFit
COMMERCIAL CONDENSING GAS
Install condensate components
Install condensate drain tee
1. See Figure 39.
2. Remove PVC fittings and gasket from the acces-
sories bag.
3. Deburr and chamfer outside and inside of 1" PVC
nipple (item 1) to ensure even cement distribution
when joining.
4. Clean nipple ends and all fittings. Dry thoroughly.
5. For each joint in the condensate line, apply the fol-
lowing. Assemble parts ONLY in the order given.
a. Apply primer liberally to both joint surfaces —
pipe end and fitting socket.
b. While primer is still damp, lightly apply ap-
proved cement to both surfaces in a uniform
coating.
c. Apply a second coat of cement to both surfaces.
Avoid using too much cement on sockets to
prevent cement buildup inside.
d. With cement still wet, insert pipe into fitting,
twisting ¼ turn. Make sure pipe is fully inserted.
e. Wipe excess cement from joint. Check joint to
be sure a smooth bead of cement shows around
the entire joint.
6. Assemble the 1" PVC nipple to the PVC condensate
drain tee (item 2). Insert the nipple completely into
the tee socket.
7. Allow joint to dry completely.
8. Slide the finished nipple/tee assembly into the
condensate drain hole.
9. Slide the gasket (item 3) over the nipple.
10. Cement the 1" coupling (item 4) to the protruding
1" nipple. Press together FIRMLY to ensure the
gasket is compressed for an air-tight seal. Hold in
place long enough for the PVC cement to set.
11. See Figure 40 for completed assembly.
Firmly press the coupling and the tee to-
gether while the cement sets to ensure the
gasket is securely compressed. The gasket
ensures the jacket enclosure is airtight at
this location.
Part number 550-100-162/0815
—
-
FIRED WATER BOILER
Condensate drain tee assembly
4
Condensate drain tee, completed
Fittings must be firmly pressed in place to
ensure an air-tight seal.
r-tight seal.
Inside
Boiler Manual Series 2
3
1
Outside
2
41
Advertisement
Table of Contents
