Table of Contents
Advertisement
Operating Procedures with WV-CU950
LCD Display Descriptions
■ Default Status (LCD Display
After Login)
MON
0032 Unit:01
q Monitor number
The number of connected monitor is displayed.
w Unit number/Status
The number of connected site will be displayed.
e Camera number
The number of selected camera is displayed.
r Input number/Recorder number/Status
The numeric input, selected recorder number, or
status is displayed.
■ Blinking
In this document, grayed (greyed) areas on the LCD
illustrations mean blinking.
∗ MON Prohibit
0001 Unit:01
Blinking
■ Messages Displayed on the LCD
The following are examples of LCD display after login.
Note:
• Some parts of LCD displays, described on this
document, may differ from the actual status.
● Invalid
MON Invalid
0001 Unit:01
This message is displayed in the following circum-
stances.
• When you have entered a wrong user ID or pass-
• When you have entered a camera number or moni-
CAM
>00512
● Busy
• When a selected monitor is controlled by a higher-
• When a selected camera is controlled by a higher-
• To cancel the Busy status, select another monitor,
● Prohibit
CAM
00001
• When you have tried an operation not authorized
• When you have forgotten to select a monitor
• After a few seconds, the LCD display will return to
CAM
00001
word, etc.
tor number, etc. that is not existing.
level user, "∗" blinks on the LCD. (You cannot con-
trol the monitor.)
level user, "∗" blinks on the LCD. (You cannot con-
trol the camera.)
camera, or wait until "∗" goes out.
∗ MON Prohibit
0001 Unit:01
"Busy" status is activated for a monitor.
MON Prohibit
0001 Unit:01
"Busy" status is activated for a camera.
MON Prohibit
0001 Unit:01
by the system unit, "Prohibit" is displayed on the
LCD.
before selecting a camera, "Prohibit" is displayed
on the LCD.
the default status.
CAM
00001
CAM∗
00001
CAM
00001
37
Advertisement
Table of Contents
