Table of Contents
Advertisement
Select Protocol and Connect to Imager
RS-232 Option
• Select RS-232 and click the Show Connect Symbol button.
• Print the RS-232 Connect Mode symbol (also shown in the Install ESP step) and
decode it to ensure that you are in the correct communications mode. Keep the printed
symbol in a convenient place for future use.
• Click Next to return to the RS-232 dialog.
• Configure RS-232 settings and COM port and click Connect.
• When you are connected successfully, the
green box in the status bar at the bottom right of the screen.
If the connection attempt fails, enable a different communications port, check your port
connections, and try again.
You are now ready to configure your imager using ESP. Subsequent sections provide
more detailed information about ESP's configuration options.
1-8
CONNECTED
message will appear in a
SIMATIC MV340 User's Manual
Advertisement
Chapters
Table of Contents
