Philips S9000 Series Manual page 33

Note: When the beard styler is attached to the handle,
the motion and pressure feedback is switched off
automatically.
Using the beard styler attachment with comb
You can use the beard styler attachment with the comb
attached to style your beard at one fixed setting or at
different length settings. You can also use it to pre-trim
any long hairs before shaving for a more comfortable
shave.
The hair length settings on the beard styler attachment
correspond to the remaining hair length after cutting and
range from 1 to 5 mm.
1 Twist the shaving head or other attachment to
remove it from the handle and press the beard styler
attachment onto the handle.
2 Slide the comb straight into the guiding grooves on
both sides of the beard styler attachment.
3 Press the length selector and then push it to the left or
right to select the desired hair length setting.
4 Switch on the appliance.
5 Move the appliance upwards while you exert gentle
pressure. Make sure the front of the comb is in full
contact with the skin.
6 Switch off the appliance and clean the attachment
after use.
33
English