Follett Symphony Plus E25CI425A Installation, Operation And Service Manual page 10

Cleaning & Sanitizing Tool Checklist
§ (2) 1 .5 Gallon (or larger) Plastic Buckets
§ (2) clean cloths
§ Sanitary gloves
§ Safety Glasses
§ (2) Sani-Sponge™ (P/N 00131524 - single sponge)
§ (1 ) Packet of SafeCLEAN Plus (P/N 01050863 - 24 packets)
Ice Machine and Dispenser
Cleaning/Descaling Procedure
Note: Check drains and drain cup to ensure they are open and flowing freely .
1. If ice machine was running recently, ensure that the evaporator is completely free of ice before proceeding .
If there is ice in the evaporator, complete steps 2-7 using only hot water to remove the ice then begin
Cleaning/Descaling Procedure again .
2. Remove front cover and turn OFF bin signal switch .
3. Dispense all ice from storage hopper and discard .
4. Remove splash panel .
5. Press CLEAN switch . The MAINTENANCE light will turn on and the machine will drain . Wait for the LOW
WATER light to turn on .
6. Remove lid from cleaning cup and fill (about 1 quart) until SafeCLEAN Plus solution completely fills the
reservoir . Place lid back on cup . Save remainder of SafeCLEAN Plus solution .
7. CLEANER FULL light will turn on and machine will start cleaning and sanitizing cycle then rinse three
times; this process takes approximately 15 minutes .
8. While ice machine is cleaning/descaling, clean dispenser as follows:
a . Turn OFF dispenser power .
b . Remove hopper lid .
c . Remove knurled nuts from front of storage hopper .
d . Remove stud assembly, baffle, wheel, and any remaining ice .
e . Remove dispense chutes from splash panel .
f . Submerse drain grill in SafeCLEAN Plus solution and allow to soak to remove any scale buildup .
g . Wipe stud assembly, baffle, wheel, inside of storage area, dispense chutes, drain grill and drain pan with
damp cloth wrung out in SafeCLEAN Plus solution . Thoroughly rinse all parts with damp cloth wrung out
with clean water .
Note: To avoid possible damage to motor assembly, only use a damp cloth to clean storage hopper . Do not
allow water to run through motor shaft hole in bottom of hopper .
h . Wipe inside of hopper lid, stud assembly, baffle, wheel, inside of storage area, dispense chutes, drain grill
and drain pan with damp cloth wrung out in SafeCLEAN Plus solution .
Note: To avoid possible damage to motor assembly, only use a damp cloth to clean storage hopper . Do not
allow water to run through motor shaft hole in bottom of hopper .
i . Reinstall dispense chutes, wheel, baffle, stud assembly and knurled nuts . (See manual for correct baffle
position .)
10 C/E25CI425A/W, C/E50CI425A/W