Instruction: Installation Of Receiver Sensor - Siemens LDS 6 Operating Instructions Manual

Installation Guidelines
Installation of Receiver Sensor
Install the loop cable in the receiver sensor according to
figure 2.4. Cables are fixed with gaskets. Always use lubricant on
the gaskets before installing, otherwise they will be very difficult
to remove later.
Connect the multi-mode fibre to the sensor-board as shown in
figure 2.4.
Figure 2.4 Connections in the receiver sensor
•
Insert the receiver detector and fix it by rotating it 90 degrees.
10
ATEX manual for LDS 6
A5E01206710-02