To Adjust The Cutting Height With Automower Connect; To Charge The Battery - Husqvarna AUTOMOWER 550 Operator's Manual

4.7 To adjust the cutting height with
®
Automower Connect
The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (6 cm / 2.5 in.).
Note:
During the first weeks after a new installation,
the cutting height must be set to MAX to avoid damaging
the loop wire. After this, the cutting height can be
lowered step by step every week until the desired cutting
height has been reached.
Settings > Cutting height .
1. Select
2. Move the horizontal bar to set the cutting height.
Save .
3. Select

4.8 To charge the battery

WARNING:
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
When the product is new or has been in storage for a
long period, the battery can be empty, charge the
battery before you start the product.
1. Set the Main switch to position
2. Put the product in as far as possible in the
charging station. Make sure that the product and
the charging station is connected. Refer to contact
and charging strips in Product overview on page 4 .
3. Make sure that the charging is in progress in the
®
Automower Connect app.
32 - Operation
Only charge the product
1 .
1439 - 007 - 07.01.2021