Husqvarna AUTOMOWER 550 Operator's Manual page 13

2. Set the main switch in position
3. Carry the product by the handle with the blade disc
away from the body.
2.3.4 Maintenance
WARNING:
upside down the main switch must always
be in the 0 position.
The main switch should be set in the
position before all work on the chassis of the
product, such as cleaning or replacing the
blades.
1439 - 007 - 07.01.2021
0 .
When the product is turned
0
CAUTION:
Never use a high-pressure
washer or even running water to clean the
product. Never use solvents for cleaning.
CAUTION:
Use the plug to disconnect
the charging station before any cleaning or
maintenance of the charging station or the
loop wire.
Inspect the product each week and replace any
damaged or worn parts. Refer to
33 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical components
in the product and the charging station, we recommend
that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wire) if there is a risk of a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked AR, AL
and G1/G2/G3.
2. Disconnect all connected wires and the power
supply.
3. Connect all the wires and the power supply if there
is no longer a risk of thunder. It is important that
each wire is connected to the right place.
Maintenance on page
Safety - 13