Husqvarna AUTOMOWER 550 Operator's Manual page 28

Note:
Drive Past Wire distance is changed, the
If the
distance will change along the boundary wire
everywhere in the work area.
To set the Drive past wire
Settings > Installation > Drive past wire in
1. Select
the app.
2. Move the horizontal bar to set the distance.
Save .
3. Select
3.11.4 Accessories
Settings for accessories mounted on the product can be
made in this menu.
3.11.4.1 To avoid collisions with the Automower
When this option is enabled, the wear on the product
®
and the Automower house is reduced, but it can result
in more uncut grass around the charging station.
Settings > Installation > Mower house in the
1. Select
app.
on/off to enable or disable the function.
2. Select
3. Select Save .
3.11.4.2 To set the ultrasonic
Settings > Installation >Ultrasonic in the
1. Select
app.
on/off to enable or disable the function.
2. Select
3. Select Save .
3.11.5 General (Bluetooth
This function is used to set time and date, or to reset to
default settings.
3.11.5.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
To set the time & date
1. Select Settings > General > Time & Date in the
app.
Time & Date from phone or select the pencil
2. Select
to enter the correct time and date.
3. Select Save .
28 - Installation
3.11.5.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
Time will not be reset.
To reset to factory settings
1.
2.
3.11.6 Security (Bluetooth
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
menu in the Automower
®
house
3.11.6.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
To create a New loop signal
1.
2.
3.
4.
®
only)
3.11.6.2 To change the PIN code
1.
2.
3.
4.
5.
3.11.6.3 Theft protection
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
Time lock
The time lock can be set between 1 to 100 days. The
factory setting is 30 days. When the selected number of
days has gone by, the product continues to operate as
usual. To enter new settings the PIN code must be
entered.
PIN code, Loop signal, Messages and Date &
Settings > General > Reset in the app.
Select
Reset to factory settings .
Select
®
® Connect app.
Put the product in the charging station.
Security > New loop signal > Create new
Select
loop signal in the app.
Select Save .
Wait for confirmation that the loop signal has been
generated. This usually takes about 10 seconds.
Security > Change PIN code in the app.
Select
Enter the PIN code.
Enter the new PIN code.
Enter the new PIN code to confirm.
Make a note of the new PIN code in Memo. Refer
to Introduction on page 3 .
Theft protection menu it is possible to set the
1439 - 007 - 07.01.2021
only)
Security