Table of Contents
Advertisement
3.3.2
Handling of Firmware Page
1.
Click 2.2 Handling of Firmware Page in the main menu.
For details about the parameters on this screen, refer to the descriptions below.
2.
Click Main Operation Mode for Operation to set the desired page as the active page on
startup.
At any time during the session, you can:
•
Click MENU to return to the main menu (see "3.1 Main Menu for the Installer").
•
Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "3.4.2 Log Out").
Note
Do not click Empty, as it is an option provided for engineer use only.
3.
Click the option for the page in the "NEW" status for Select Page to specify it as the target
page of the operation.
4.
Click OK.
You will see a confirmation screen.
5.
Click OK.
You will see a result screen.
6.
Click OK.
You will be taken back to the Handling of Firmware Page screen.
Parameter Descriptions
Parameter & Description
Program Version
Indicates the current version of the two firmware data
in the VoIP Gateway Card: page 0 and page 1.
Default
Value Range
Display only
3.3 Data Management
Programming Guide
61
Advertisement
Table of Contents
