Handling Of Firmware Page - Panasonic KX-TDA0490 Getting Started

3.3.2

Handling of Firmware Page

1.
Click 2.2 Handling of Firmware Page in the main menu.
For details about the parameters on this screen, refer to the descriptions below.
2.
In Operation, click Main Operation Mode to set the desired page as the active page on startup.
Note
Do not click Empty, as it is an option provided for engineer use only.
At any time during the session, you can:
• Click MENU to return to the main menu (see "3.1 Main Menu for the Installer").
• Click LOGOUT to log out from the IP-GW16 Maintenance Utility (see "3.4.2 Log Out").
3.
In Select Page, click the page whose current firmware status is not "Main Operation Mode" to
specify it as the target page of the operation.
4.
Click OK.
You will see a confirmation screen.
5.
Click OK.
You will see a result screen.
6.
Click OK.
You will be taken back to the Handling of Firmware Page screen.
Parameter Descriptions
Parameter & Description
IP-GW16 Program Version
Indicates the version of the VoIP Gateway Card's main
programme in the firmware data of the corresponding page.
DSP Program Version
Indicates the version of the VoIP Gateway Card's DSP
programme in the firmware data of the corresponding page.
Default Value Range
Display only
Display only
3.3 Data Management
Programming Guide 65