Table of Contents
Advertisement
2.2 Programming
2.2.4
VoIP Gateway/IP-PBX Interface Parameters
1.
Click 1.4 VoIP Gateway/IP-PBX Interface Settings in the main menu.
2.
Assign each parameter referring to the descriptions below.
At any time during the session, you can:
•
Click ALL CLEAR to reset all parameters to the default values.
•
Click MENU to return to the main menu (see "2.1 Main Menu for the Administrator").
•
Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
3.
Click OK.
You will see a confirmation screen.
Note
If your entry contains an invalid value, you will see an error screen. Click OK and try
again with correct values.
4.
Confirm your entry and click OK.
To return to the previous screen, click CANCEL.
Parameter Descriptions
The parameters indicated with "*" must be changed while the VoIP Gateway Card is in the "STOP"
status (see "2.3.1 Status Control"). The changes do not have to be followed by a reboot to become
effective.
Dialling Settings
Parameter & Description
*
First Digit Time (s) 5-30s
Specifies the length of time (in seconds) within which
the first digit of a dial number must be dialled after
seizing a VoIP gateway trunk.
Generally, there is no need to change the default value.
24
Programming Guide
Default
Value Range
20
5 to 30
Advertisement
Table of Contents
