Table of Contents
Advertisement
2.3
Maintenance
2.3.1
Status Control
1.
Click 2.1 Change RUN/STOP status in the main menu.
Current RUN/STOP Status shows the current status of the VoIP Gateway Card.
2.
Click RUN or STOP for Status after changing.
If you want to forcibly change the status from "RUN" to "STOP" while there are ongoing
calls, click the Yes check box for Forced Disconnect when executing STOP. This will
allow you to place the card in the "STOP" status even when there are ongoing calls.
At any time during the session, you can:
•
Click MENU to return to the main menu (see "2.1 Main Menu for the Administrator").
•
Click LOGOUT to log out from the IP-GW4 Maintenance Utility (see "2.5.2 Log Out").
3.
Click OK.
You will see a confirmation screen.
4.
Click OK.
You will see a result screen.
Note
If the operation is not successful, you will see an error screen. Click OK to return to
the previous screen, and then try again.
5.
Click OK.
You will be taken back to the Change RUN/STOP status screen.
2.3 Maintenance
Programming Guide
39
Advertisement
Table of Contents
