2.1.2
Installing the VoIP Gateway Card in the PBX
Install the VoIP Gateway Card in slot 05, 06, or 07 of the KX-TDA50 PBX.
1.
Before installing the card, cut and remove the dummy cover plate for the appropriate slot
from the main unit.
CAUTION
For safety reasons, smooth the cut edges after removing the dummy cover plate.
2.
Position the card in the open slot, making sure that the tabs on both sides of the card fit
into place. Then, holding the card firmly in place, lower the rear end so that the hole of the
card fits over the extension bolt.
Extension Bolt
Dummy Cover Plate
2
2.1 Installation
1
Getting Started
15