Lubrication - Scag Power Equipment TurfTiger II STTII-52V-25CH-LP-EFI Operator's Manual

Section 7
MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS (CONT'D)
HOURS
BREAK-IN
8 40
(FIRST 10)

7.2 LUBRICATION

GREASE FITTING LUBRICATION CHART (SEE FIGURE 7-1)
LOCATION
1 Caster Wheel Pivot *
2 Caster Wheel Bearings
3 Cutter Deck Drive Shaft Slip Sleeve
4 Cutter Deck Bellcranks
5 Cutter Deck Pusharms
6 PTO Spindle
7 Cutter Deck Spindle
8 Cutter Deck Drive Shaft U-Joints
+ Compatible Greases:
* PROCEDURE: Remove grease cap, part number 484195. Remove plug, part number 482028-01, and install grease
zerk. Apply grease to the fitting until new grease appears at the top of the caster extension. Remove the grease
zerk and reinstall the plug. Reinstall the grease cap. Special tool, part number 47007, is recommended for use in the
installation of the grease cap.
100 200 500
Apply grease to fittings
X
Check hardware for tightness
X
Change engine oil filter
X
Check hydraulic oil level
X
Replace engine fuel filter
X
Service LPG fuel system
X
Drain hydraulic system and replace
X
hydraulic oil
Replace hydraulic oil filter
X
R e p l a c e c u t t e r d e c k g e a r b ox
X
lubricant
Change coolant
X
LUBRICATION INTERVAL
500 Hours/Yearly
100 Hours/Monthly
40 Hours/Weekly
100 Hours/Bi-Weekly
100 Hours/Bi-Weekly
40 Hours/Weekly
40 Hours/Weekly
200 Hours/Monthly
Scag Premium Chassis Grease p/n 486257
Scag Premium Spindle Grease p/n 486258
PROCEDURE
LUBRICANT
Chassis Grease
Chassis Grease
Spindle Grease
Chassis Grease
Chassis Grease
Spindle Grease
Spindle Grease
Chassis Grease
35
COMMENTS
See paragraph 7.2
See paragraph 7.4
See paragraph 7.3
See paragraph 7.5
See paragraph 7.6
Use SAE 20W50 Motor Oil.
See paragraph 7.3
See paragraph 7.3
See paragraph 7.12
See paragraph 7.13
NO. OF
PLACES
2
2
1
4
2
1
3
2
R