Table of Contents
Advertisement
6
Hawk 2LP Family Installation Guide, Rev. A
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Safety instructions
1.
The disc drive(s) are to be installed in a customer supplied
enclosure where the surrounding air does not exceed
o
50
C.
2.
Four (4) 6-32 UNC-2A screws are required for installation.
Maximum screw length into side of drive is 0.15 inches
(3.81 mm). Maximum screw length into bottom is 0.20 in.
(5.08 mm). Screw tightening torques is 6.0 lb-in (.675 NM)
max with minimum thread engagement of 0.12 in (3.00
mm).
3.
The power requirements are shown in the Product Infor-
mation section.
4.
The power supply must satisfy the safety requirements for
SELV (Safety Extra Low Voltage) circuits.
5.
Service is to be provided by trained Seagate service
personnel.
6.
The incorporation of the disc drives listed in this guide into
a customer enclosure must meet the appropriate safety
requirements of the country in which it is used (e.g. UL
1950, CAN/CSA-C22.2 No. 950-M89, DIN VDE 0805:1993
and EN60950: 1992 (IEC 950).
Power must be off when connecting or disconnecting.
Note
Advertisement
Table of Contents
