Seagate HAWK 2LP ST31231N Installation Manual page 34

32 Hawk 2LP Family Installation Guide, Rev. A
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
[3]
C
G
[1]
A
B
J
[2]
H
K
N
M
[4]
Figure 4. Hawk 2LP family N/ND model mounting
dimensions (50 pin SCSI I/O connector)
L [4]
D
F
E
Notes:
[1] Mounting holes three on each side, 6-32 UNC.
Max screw length into side of drive 0.15 in.
(3.81 mm). Maximum torque 6 in-lb (.675 NM).
Min. thread engagement 0.12 in. (3.0 mm).
[2] Mounting holes four on bottom, 6-32 UNC.
Max screw length into bottom of drive 0.20 in.
(5.08 mm). Maximum torque 6 in-lb (.675 NM).
Min. thread engagement 0.12 in. (3.0 mm).
[3] Power and interface connectors can extend
past the "A" dimension by 0.040 in. (1.02 mm).
[4] Decorative front panel (optional).
Inches Millimeters
A 5.74 ± .010 145.80 ± .25
B 4.00 ± .010 101.60 ± .25
C 1.00 + .026 25.40 + .66
– .010 – .25
D 2.362 ± .010 60.00 ± .25
± .25
E .620 ± .010 15.75
F 4.000 ± .010 101.60 ± .25
G .250 + .010 6.35 + .25
– .005 – .12
± .25
H 1.750 ± .010 44.45
J 3.750 ± .010 95.25 ± .25
K 2.370 ± .010 60.20 ± .25
P
L 1.00 + .026 25.40 + .66
– .010 – .25
M 4.000 ± .010 101.60 ± .25
N 0.19 ± .010 4.83 ± .25
P 0.015 max 0.381 max