Electrical Installation Instructions (240V Service) - Sundance Spas 880 Series Owner's Manual

880 Series
6.0

Electrical Installation Instructions (240V Service)

IMPORTANT NOTICE: The electrical wiring of this hot
tub must meet the requirements of the National Electrical
Code (NEC) and/or any applicable state, local or country
codes. The electrical circuit must be installed by a qualified
electrician and approved by a local building/electrical
inspection authority in your state or country.
DANGER:
!
1.
PRODUCT DAMAGE OR ELECTRICAL FIRE.
This hot tub must be permanently connected (hard-wired) to the
power supply. No plug-in connections or extension cords are
to be used in conjunction with the operation of this hot tub.
Supplying power to the hot tub which is not in accordance with these
instructions will void both the independent testing agency listing and
the manufacturer's warranty.
2. The power supplied to this hot tub must be a dedicated circuit with no
other appliances or lights sharing the power provided by the circuit.
3. To determine the current, voltage and wire size required, refer to
Section 7.0 (page 15) for your specific hot tub model.
• Wire size must be appropriate per NEC and/or local/country codes.
• The spa controller's terminal block will accept a maximum wire size
of 6 AWG.
4. The electrical supply for this product must include a suitably rated
switch or circuit breaker to open all ungrounded supply conductors
to comply with Section 422-20 of the National Electrical Code, ANSI/
NFPA 70. The disconnecting means must be readily accessible and
visible to the hot tub's occupant but installed at least 5 feet (1.5m)
from the hot tub.
5. The electrical circuit supplied for the hot tub must include a suitable
ground fault circuit interrupter (GFCI) as required by NEC Article
680-42.
6. To gain access to the hot tub's power terminal block, remove the
screws securing the center cabinet panel (Maxxus™ and Aspen®
models only) or the Quick Release buttons (except Maxxus and Aspen
models) on the side of the hot tub under the controls. Then remove the
control box door screws and door (Figure C, page 14).
7. Select the power supply entrance you want to use (Figures A-B,
pages 13-14) and remove the short cabinet panel from the front
of the hot tub, then feed cable through the large opening provided on
the bottom of the control box.
12
TO DECREASE THE RISK OF SHOCK,