Registration And Start-Up; Start-Up Sequence; Register Your New Spa - Sundance Spas 880 Series Owner's Manual

10.0 Registration and Start-up

10.1

Start-up Sequence

When power is first applied, the iTouch™ control panel will display a wel-
come message and the current software revisions, Figures 10.1a. Then
the spa will begin a blow out cycle, Section 12.5, page 61.
Note: The start up menu will time out after approximately 3 seconds
and then change to the registration display in Section 10.2.
WELCOME
Connecting to Spa...
10.2

Register Your New Spa

Registering your spa is important in order to
validate your warranty, Figure 10.2a. In order
to register you will need to have the spa serial
number, Figure 10.2b, then you will need to
register online in order to receive a passcode.
The passcode must be entered on the control
panel in order to unlock the registration
lockout.
If this option is skipped, you will be able to activate components, but
after 10 minutes, the screen will revert back to the registration screen.
This process will continue until the spa is registered and the passcode is
entered.
Note: The spa will still protect itself if an error is detected.
To register your spa you need to have
your spa serial number. The best time
to retrieve the serial number is when
the spa is being connected. You must
register your spa via the internet at
www.SundanceSpas.com.
Spa 1.20 / Panel 2.10
Figure 10.1a
WELCOME
Registration Lockout
Please register your spa at:
www.SundanceSpas.com
Once registered, enter your
spa serial # and registration
passcode here:
Enter #
Figure 10.2a
102 °
DANGER!
TURN POWER
OFF! DO NOT
LOOK AT LIT BULB.
SEVERE EYE
DAMAGE OR BLINDNESS
CAN OCCUR!
Power Lamp
on on
serial
Figure 10.2b
nameplate
880 Series
Later
45