Optional Wi-Fi Setup (50Hz Models Only) - Sundance Spas 880 Series Owner's Manual

880 Series
Note: Pressing
revert to the previous programmed setting. This feature can be used to
make corrections.
3. Tap to confirm and save your changes.
4. Tap to return to the "Water Care" Menu. Tap again to return to the
Settings Menu.
5. When the timer expires, a message will appear on the control panel
display. Follow the previous instructions to reset the timer. The
filter must be replaced. Refer to Section 13.1, page 69, for filter
location. If you tap "snooze" the message will clear but the error icon
will display and the reminder screen will reappear in 10 days.
12.7

Optional Wi-Fi Setup (50Hz models only)

From the Settings Menu, tap
Tap
Wi-Fi
12.7b. Make sure that you have downloaded the Wi-Fi App for this setup.
A
A
Figure 12.7a
1. You need to follow the instructions from the App in order to connect
the Wi-Fi.
2. While the system attempts to connect you will see the, "Spa Wi-Fi
Setup in-progress," Figure 12.7b. When the connection is done the
display will read, "Spa Wi-Fi Setup Successfully Connected."
If the Wi-Fi connection setting should need to be updated or connected
to a new router, follow the steps below.
1. From the "Settings" menu, tap
the menu.
2. Tap
Reset?
Reset?
Setup In-progress."
3. Tap
Reset?
Reset?
to connect to the new data.
4. Reconfigure and setup your spa by following the instructions from
the app.
64
will clear any current changes made. The days will
to enter the programming options, Figures 12.7a and
SETTINGS
Water Care
Wi-Fi
Lock
, Figure 12.7b. The display will change to "Spa Wi-Fi
again. This will clear the current data and allow the spa
or to highlight the "Wi-Fi" Menu tab.
A
A
Wi-Fi Connect
Figure 12.7b
Wi-Fi
Wi-Fi setup
in progress
Reset? Reset
(Figure 12.7a) to enter