Table of Contents
Advertisement
1. Park the machine on a level surface, disengage the
power take off (PTO), set the parking brake, and turn
the ignition key to off. Remove the key.
2. Adjust height-of-cut lever on mower to the middle of
the range and lower attachment lift.
3. Carefully rotate blades so they are facing front and rear
(Fig. 9).
4. Measure between the tip of the front blade (Fig. 9) and
the tip of the rear blade to the flat surface. If the front
blade tip is not 1/8–1/4 in. (4–7 mm) lower than the rear
blade tip adjust rear adjustment link.
Front
2
4
Figure 9
1. Blade front to rear
2. Measure front blade tip
5. To adjust front-to rear blade slope turn locknut on rear
adjustable link (Fig. 10).
Note: To raise the front of the mower, turn locknut
clockwise, to lower front turn counterclockwise.
1
2
Figure 10
1. Adjustable link
1078
3
1
4
3. Measure rear blade tip
4. Measure here
m–5619
2. Locknut
Transport Height Adjustment
Transport height is adjusted to stabilize the mower in the
up, locked position.
1. Raise attachment lift lever all the way to the latched
position. Check if bumpers, on rear of mower draft bars
contact under footrests.
2. Adjust lift chain by turning trunnion on eyebolt in rear
hole of tractor lift (Fig. 11). Turn trunnion clockwise to
raise or counterclockwise to lower mower.
Note: Transport level stops are normally in the bottom of
the slot, however they can be adjusted up for side-to-side
level when extra weight from a grass catcher is on one side.
3. To adjust side–to–side level, loosen the leveling bolts.
(Fig. 11).
4. Adjust the deck level and then tighten leveling bolts.
(Fig. 11).
5
Figure 11
1. Bumper
2. Trunnion
3. Leveling bolts
9
2
1
4
3
m–2813
4. Transport level stop
5. Hairpin cotter
Advertisement
Table of Contents
