Table of Contents
Advertisement
WARNING
Using a drill without proper eye
protection may allow debris to enter the
eye, causing injury.
When drilling, always wear eye
protection.
2.
Use a 9/32 inch drill bit to drill through the 2
marked hole locations.
Note:
Do not push the drill bit too far past the
plate when drilling.
3.
Use 2 screws (5/16 inch) to secure the lower
mount bracket to the machine.
Figure 8
1. Lower mount bracket
4.
Use compressed air to remove the metal
shavings from drilling.
5.
Use 2 carriage bolts (1/4 x 3/4 inch) and 2 nuts
(1/4 inch) to secure the adjustment plate to the
lower mount bracket.
Figure 9
1. Lower mount bracket
2. Carriage bolt (1/4 x 3/4
inch)
g441547
2. Screw (5/16 inch)
g441563
3. Adjustment plate
4. Nut (1/4 inch)
6.
Use 2 hex-head flange screws (1/4 x 1-1/2
inches) and 2 nuts (1/4 inch) to secure the
small backer plate and small fist clamp to the
adjustment plate.
1. Small fist clamp
2. Small backer plate
5
Figure 10
3. Nut (1/4 inch)
4. Hex-head flange screw
(1/4 x 1-1/2 inches)
g441614
Advertisement
Table of Contents
