Fine Setting Of The Speakers; Advanced Setting - RCA RT2380 User Manual

B_RT2380 EN 4/7/04 1:44 PM
Advanced Sound Control

Fine Setting of the Speakers

All the basic settings have already been pre-set for the
speakers included in the box.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room, you
may need to delay the signal coming from some of the
speakers. Channel delay compensates for center or
surround speakers that are closer to the listening
position than the front speakers. You can make use of
the SETUP button to adjust the speakers' relative
loudness.
Testing Speaker Loudness
You can listen to the loudness of the individual
speakers.
1. Press and hold LEVEL on
the remote control.
A short noise will be
heard in the speakers one
by one. The speaker
having the noise at that
moment will be shown in
the display.
2. To adjust the volume level of the test tone, turn the
VOLUME knob or press the VOL Up or DOWN
buttons on the remote control to adjust the master
volume (if necessary).
Press LEVEL again and
press the Up or Down
buttons to adjust the
individual channel noise
level.
20
Page 24
Adjust Individual Speaker Volume
1. To adjust individual speaker volume level, press the
LEVEL key on the remote control.
2. Continue to press the LEVEL button on the remote
control to select the channel to be adjusted, then
press the Up or Down buttons to adjust
the level.
You can adjust the master volume level by turning the
VOLUME knob or press the VOL UP or DOWN buttons
on the remote control.

Advanced Setting

Factory defaulted Advance setting
indication from VFD
The receiver has defaulted the following distances:
Front
Center
Left
Cch
Lch
L/S
Rear
Left
Front speakers (FRNT)
Center speaker (CNTR) 15 ft
Rear speaker (SURR)
Front
Right
Rch
R/S
Rear
Right
15 ft
10 ft