Mounting The Stands; Disconnecting The Stands; Adjusting The Height Of The Stands; Setting The Speakers - RCA RTD260 User Manual

RTD260 EN (07_06_06)
2
Illustrations contained in this document are for representation only.
15/6/06 4:34 PM

Mounting the Stands

1. Secure the speaker stand holder with the screw provided
through the lower hole on the holder as illustrated.
2. Tighten the screw to fix the speaker on the speaker stand
holder.

Disconnecting the Stands

Loose the screw which fixes the speaker on the speaker stand
holder.

Adjusting the Height of the Stands

1. Rotate the plastic lock anti-clockwise to release.
2. Adjust the height of the stand and hold.
1
3. Rotate the plastic lock clockwise to lock.
Configuration 2
If placing the rear speakers (surround speakers) at the back is not
a good choice for you, you can use the Front Surround sound
Effect(FSsE). Follow the following instruction for setting the
speakers, speaker stands (optional) and the setup menu of the
Player.

1. Setting the Speakers

3

Mounting the Speakers

Note: Match the front left and rear left speakers together and match the front
right and rear right speakers together.
1. Place the front speaker upside down.
2. Slide in the hinge to the bottom of the front speaker until
the 'click' sound is heard.
3. Slide in the rear speaker to the hinge until the 'click' sound is
heard.
4. Attach the four rubber feet provided to the top of the front
speaker.
Page 13
Connections and Setup
EN
9