Using The Remote To Control Additional Components - RCA RT2380 User Manual

B_RT2380 EN 4/7/04 1:44 PM
Operating your Receiver
You can connect up to 6 audio/video sources to this
amplifier:
Source button
(receiver front panel)
- DVD
- SAT
- TV
- VCR
- CD
- TAPE
- FM/AM
An arrow points to the source name selected shown on
the display.
Example: Press DVD to select DVD as the source to the
amplifier.
NOTE
1. Your receiver has a built in tuner. Just
connect the appropriate antenna to the
back of the receiver and you will be able to
listen to radio stations. (See details in Tuner
section)
2. Other sources can be connected to the
above standard source. Example: you can
connect a LD into the DVD inputs.
3. Refer to the "Connecting To Audio-Visual
Components" section for details on
connection.
Using the Remote to Control Additional
Components
You can use your remote to control most of RCA
branded VCRs, satellites, cable boxes or TVs.
Press the corresponding source button on the remote
control to operate options on other components.
14
Page 18
Corresponding connector
(receiver back panel)
DVD IN (audio / video)
SAT IN (audio / video)
TV IN (audio only)
VCR IN/OUT (audio / video)
CD IN (audio only)
TAPE IN/OUT (audio only)
built-in
NOTE
The remote control can only operate RCA
brand products.
Volume Punchthrough
NOTE
Volume punchthrough can be done in all
non-Tuner modes.
By default, the VOL+/VOL- and MUTE buttons will only
control the receiver, regardless which mode (TV, VCR,
etc) the receiver is in.
By programming the volume punchthrough function,
you can also control the volume of the TV.
NOTE
Controlling the TV volume can be done in any
non-Tuner modes.
To activate the volume punchthrough function, follow
the procedures below:
1. Press and hold the VOL- button.
2. While holding down the VOL- button, press one of
the source buttons to select the source where you
want to control TV volume at. (DVD, TV, VCR or
SAT•CABLE)
3. Continue holding down the VOL- button and press
the TV button once.
4. Release all buttons.
You should now be able to control TV volume and mute
at the selected device.
HINT
To return to controlling receiver volume and
mute again, follow the steps above but press
TUNER instead of TV in step 3.
HINT
If batteries are removed from the battery
compartment of the remote control, the
volume and mute control in all source modes
will be the receiver volume and mute conrol
except in TV mode.