Setting The Voice Prompt Volume; Setting The Voice Chime Volume; User's Walk Test - DSC neo HS2128 E User Manual

Chapter
8

8.11 Setting the Voice Prompt Volume

This feature is only available when using an HS2LCDWFPV wireless keypad.
To change Voice Prompt volume:
1. From the User Function menu use the shortcut key [1][5] or press the
scroll keys to select Voice Prompt and press [*].
2. Enter the 2 digit value or scroll to the desired volume level and press
to return to the previous menu.
3. Press [#] to return to the Ready state.

8.12 Setting the Voice Chime volume

This feature is only available when using an HS2LCDWFPV wireless keypad.
To change Voice Chime volume:
1. From the User Function menu use the shortcut key [1][6]or press the
scroll keys to select Voice Chime and press [*].
2. Enter the 2 digit value or scroll to the desired volume level and press
[#] to return to the previous menu.
3. Press [#] to return to the Ready state.

8.13 User's Walk Test

Allows the user to verify the operation of system detectors and notifies the central station that a Walk Test
is in progress and must be configured by installer.
During a system (walk) test, do not activate any:
IMPORTANT:
Fire, Auxiliary or Police buttons
l
Fire or CO sensors
l
A full system test is comprised of activating each sensor in turn. Open each door, window and walk-in
areas with motion detectors. It is recommended you perform system tests during off-peak hours, such as
early morning or late evening.
To initiate a Walk Test:
1. From the ready state press [*][6] and enter the [Master Code] to
access User Functions.
2. Press [08] or use the scroll keys to navigate to Walk Test and press
[*]. The system activates all keypad sounders and bell/sirens for two
seconds and also notifies the central Station that a walk test has
begun.
3. Trigger each detector (zone) in sequence. A squawk occurs at the
keypad, all LEDs on the keypad will flash and the violation will be
recorded in the Event Buffer.
4. Restore zones. Press [*][6][Master Code][8] to end the Walk Test.
The system will notify the Central Station that the walk test has been
terminated.
NOTE: Fire zones, the 'F' key, and 2-wire smoke detectors are excluded from this test. Violation of these
zones will cause the system to exit the walk test then generate and transmit an alarm condition to the
central station.
If a zone is not violated within 15 minutes of activating the Walk Test, the system will automatically exit
the Walk Test and resume normal operation.
NOTE: This feature is not available in CP-01 panels.
To Enable/Disable a Walk Test:
1. From the User Function menu, use the shortcut key [08] or press [<]
[>] to scroll to Walk Test.
2. Press [*] to enable/disable the Walk Test feature.
- -
31
LCD Display
Press (*) for <>
Voice Prompt
Voice Prompt <>
Level... XX
LCD Display
Press (*) for <>
Voice Chime
Voice Chime <>
Level... XX
LCD Display
Press (*) for <>
User Functions
Press (*) for <>
Walk Test
LCD Display
Press (*) for <>
Walk Test
Walk Test
is Enabled