Table of Contents
Advertisement
Operation
Basic system reset
Advanced system
reset
USB One Touch Copy button
The USB One Touch Copy button allows you to copy data backups from a USB device to the NAS or from the
NAS to a USB device.
This feature supports incremental backups. The NAS only copies files that were modified or added after the
last backup.
To configure the behavior of the button when an external device is connected to the button's USB port,
install and use Hybrid Backup Sync on your QNAP operating system. For details, see the
documentation.
LCD panel
The LCD panel allows you to perform the following operations:
• Restart and power off the device
• Configure or change the LCD panel password
• View and configure network settings
User Action
Press and hold the
button for 3 seconds.
Press and hold the
button for 10 seconds.
The following settings are reset to default:
• System administrator password: The default password
is the first MAC address in uppercase letters
without special characters. For example, if the first
MAC address is 00-08-9B-F6-15-75, then the admin
password would be 00089BF61575.
Tip
You can find the first MAC address with
Qfinder Pro or attached to a label on the
device listed as MAC1.
• TCP/IP configuration:
• Obtain IP address settings automatically via DHCP
• Disable jumbo frames
• If port trunking is enabled (multi-LAN models
only), the port trunking mode is reset to "Active
Backup (Failover)".
• System port: 8080 (system service port)
• Security level: Low (Allow all connections)
• LCD panel password: (blank)
• VLAN: Disabled
The default factory settings are restored.
To retrieve old data after an advanced system reset,
recreate the previous folder structure on the NAS.
TS-1655 User Guide
Result
Hybrid Backup Sync
Basic Operations
57
Advertisement
Table of Contents
