Panasonic KX-NS700 Feature Manual page 194

2.13.1 Call Hold
Mode 2
(Default) Hold Feature No.
Going on-hook
Mode 3 Hold Feature No.
Going on-hook
Mode 4 Hold Feature No.
Going on-hook
*1 These operations must be performed when the held call is intended to be retrieved from another extension using the holding
extension number.
If the following occurs frequently with an SLT, choose "Mode 2", "Mode 3", or "Mode 4":
a.
When an SLT user receives a call, reorder tone is heard or nobody answers the call.
b.
When an SLT user goes off-hook, reorder tone is heard instead of a dial tone.
If a call is not terminated after going on-hook, the above cases occur. To avoid these problems, choose
"Mode 2", "Mode 3", or "Mode 4". Every call will be terminated unless the Hold feature number is entered
after flashing the hookswitch in Mode 2, Mode 3, and Mode 4.
•
Hold Alarm tone pattern has a default. (® 6.2.1 Tones/Ring Tones).
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Dial / IRNA / Recall / Tone
→ Recall—Hold Recall (s)
→ Recall—Disconnect after Recall (x60s)
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features
→ Call Hold / Call Hold Retrieve
→ Call Hold Retrieve : Specified with a Holding Extension Number
→ Hold Retrieve : Specified with a Held CO Line Number
10.9 PBX Configuration—[2-9] System—System Options
→Option 1—
→Option 1—
→Option 5—
PT Programming Manual References
[200] Hold Recall Time
194 Feature Manual
Hold (to be Retrieved from
Another Extension)
Flashing the Flashing the hookswitch
hookswitch
+ Hold Feature No.
+
Flashing the Flashing the hookswitch
hookswitch
+ Hold Feature No.
+ Hold Feature No.
Flashing the Flashing the hookswitch
hookswitch
+ Hold Feature No.
+ Hold Feature No.
PT Operation—Automatic Hold by ICM / CO / ICD Group Key
PT Operation—Hold key mode
SLT—SLT Hold Mode
Hold
*1
+
+
Going on-hook
+
+
+
Going on-hook
+
+
+
Going on-hook
Transfer to Trunk
Flashing the
hookswitch
+
Trunk Access No.
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Flashing the
hookswitch
+
Hold Feature No.
+
Trunk Access No.
Transfer to
Extension
Flashing the
hookswitch
+
Extension No.
Flashing the
hookswitch
+
Extension No.
Flashing the
hookswitch
+
Hold Feature No.
+
Extension No.