Hunter Bennett Collection Installation Manual page 9

Remove the cardboard plug
guard before proceeding!
Connect the plugs from
the fan and light fixture.
Make sure to line up
the colored markings
on the connectors.
Need a little more help with assembling this light?
Visit our light kit video at:
Note:
Fan style may vary.
Ceiling Bracket Downrod
Assembling the Light
Push the connector and
excess wire into the hole at
the top of the light fixture.
IMPORTANT
The connector and excess wiring
must be pushed into the light
fixture in order to successfully
mount the light fixture to the fan.
HOLD HERE
http://bit.ly/HunterQuickConnect
Installing the Bulb and Glass
bag
Install the shades onto the
sockets. Install the socket
rings, found in the hardware
bag, onto the sockets. Tighten
them by turning clockwise
with the socket ring glass tool.
Repeat x3
Hanging Fan Wiring
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
Hold the fan body stationary and rotate
the light fixture clockwise to engage the
locking pin.
x3
Socket Ring
Hunter Pro Tip:
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs
fan without the light kit?"
Canopy Blades
Notch
Some components not shown for visual clarity.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Repeat x3
Install each included bulb into their
sockets. When necessary, replace
with bulbs of the same wattage.
and click "How do I install my
Light Remote Troubleshooting
1886
Pin
8