Table of Contents
Advertisement
1886
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
Battery
Door
Phillips
Head
Screw
ON
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket
Downrod
Preparing the Remote
To access the battery compartment, remove the small Phillips head
screw that secures the battery door to the transmitter assembly. The
battery should be installed with the positive (+) side up. Replace with
a CR2032 battery when necessary.
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan
Wiring
NOTICE
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Replace all batteries of a set at the
same time.
• Clean the battery contacts and also
those of the device prior to battery
installation.
• Ensure the batteries are installed
correctly with regard to polarity (+
and -).
• Remove batteries from equipment
which is not to be used for an
extended period of time.
• Remove used batteries promptly.
NOTICE
To enable dimming, your remote must be set to
Dimming Mode. To toggle Dimming Mode on or off,
long press the "Fan Speed Up" button and "Fan
Speed Down" button.
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Canopy
Blades
: DIMMING MODE
Slide the cradle onto
the mounted bracket.
Light
Remote
Troubleshooting
Advertisement
Table of Contents
