Preparing The Remote - Hunter Visalia Installation Manual

The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
Ceiling Bracket Downrod
Battery
Door
Phillips
Head
Screw
Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Hanging Fan Wiring

Preparing the Remote

To access the battery
compartment, remove the
small Phillips head screw that
secures the battery door to
the transmitter assembly. The
battery should be installed
with the positive (+) side
up. Replace with a CR2032
battery when necessary.
Option 2: Using Screws
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Canopy Blades
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
ON
Choose your cradle
installation location.
Light Remote
1886
Slide the cradle onto
the mounted bracket.
10
Troubleshooting